200A-MLHZA
Specifications
Performance Characteristics:
Type: Multipath Limiting High Zenith Antenna Cross-V-Dipole Array
Frequency Range: 1575.42 MHz ±10 MHz
Polarization: Right Hand Circular Polarization
Impedance: 50 ohm nominal
VSWR: Not greater than 1.3:1 Measured At End Of Low Loss Cable Not Exceeding 5 Feet In Length.
Direction of Max Gain in Elevation: Upward Looking
Maximum RHCP Pattern Variation Through all Azimuth Angles and Elevation Angles Between 30° and 90° (Taken to be the Algebraic Sum of the Maximum Azimuth Pattern Variation and the Maximum Elevation Pattern Variation) Note: 30° is 30° above horizon plane and 90° is perpendicular to horizon plane: < or = 11 dBic
Peak Antenna Gain: > 1 dBic
Desired-To-Undesired Signal Ratio Between 30° and 90° in Elevation: 95% of the Elevation Measurements Must Meet The Desired-To-Undesired Signal Performance Requirement Shown In Figure 3-3, when Averaged Over Azimuth.
Ellipticity Ratio at Beam Peak: < 2 dB
Radome Coverage: Entire Antenna weather proofed and Covered by Radome. Removal/replacement of subassemblies possible without sealing compounds.
Connector for Feed: Connector at output of LNA inside of MLHZA is Type SMA jack, Connector at Bottom of MLA is Type N Jack.
Transmitting or Receiving: Receive Only
Lightning Protection and Obstruction Lights: Provided via dBs 200-ADA. Adapter for Obstruction Lights, Lightning Protection, Air Terminals and Physical Mount for dBs 200A-HZA antenna. Height 33" x Width 35" x Depth 6" x 18 Lbs. Obstruction Light Connector is MS-3112E8-3P.
FAA Environmental Requirements: FAA-G-2100F, Environment III
MLA Low Noise Amplifier & Filter: Located within HZA Antenna. 25 dB Gain, Noise Figure < or = 1.5 dB, 50 dB Out-of-Band Rejection, +7 to +32 VDC Input.
Back
Today's Date: Monday, February 06th 2012 12:46:55 AM MST