510A-L DME ANTENNA, OMNI-DIRECTIONAL, Lightweight with Integral Pipe Mount
Specifications
Performance Characteristics:

Back

  • Type: Omni-directional

  • Circularity: ± 1 dB max on horizon

  • Frequency Range: 960 through 1215 MHz ( no adjustments or tuning required)

  • Array: 8 radiator assy's

  • Coaxial Cable: Semi-Rigid, Low Loss, Phase Stable

  • Polarization: Vertically Polarized

  • Gain, main beam: 8 dB/iso, minimum

  • Gain, horizon: 6 dB/iso, minimum

  • Main beam elevation location: Between 2° and 5° above horizon

  • Slope (Vicinity of horizon): .44 dB/°, .05 V/V/°

  • Power Handling Capability: Up to at least 10 kW peak RF power at 3% duty cycle

  • Impedance: 50 ohm nominal

  • VSWR: Not greater than 2:1 (960-1215 MHz) measured at end of low loss cable not exceeding 5 feet in length.

  • Vertical Field Pattern: The radiation pattern of the antenna in the vertical plane has a lobe of energy not less than 10 degrees wide at the half-power points. The power gain at angles between 6 and 50 degrees below the horizon shall be lower than the power gain at the peak of the major lobe above the horizon by at least 8 dB. The power gain at angles between 6 and 15 degrees above the horizon shall be greater than a level which is 20 dB below the power gain at the peak of the major lobe above the horizon. The power gain at angles between 15 and 45 degrees above the horizon shall be greater than a level which is 30 dB below the power gain at the peak of the major lobe above the horizon.

  • Size: 64" long, 8 radiator assemblies (driven elements) plus a choke assembly at each end, 3 1/4" OD radome. Has top cap and base collar.

  • Weight: 10.2 lbs.

  • Physical Design: A metal tube, 1.5" OD x 1.43" ID (.040" wall thickness) runs through center of antenna for full length. RF transmission line assembly and obstruction light power lines are located within this tube. Also used as lightning down conductor.

  • Weather Proofing: Entire Antenna, including all cable connectors is weather proofed such that removal/replacement of radome is possible without sealing compounds.

  • Antenna Mounting: The configuration of the antenna base is such that the antenna can be mounted directly to a Supporting 3” O.D. Pipe or Conduit.

  • Temperature: Operational Temperature Range -50 degrees C to +70 degrees C.

  • Wind Loading: Withstands without damage 100 mile per hour gusts

  • Monitor Ports: Not Provided

  • Obstruction Light(s): Interface not Provided

  • Connectors RF: Type N Female, 1 each.

  • Environmental:
    • Meets FAA-G-2100c Environment III and FAA-E-2754.
    • Temperature, -50 to +70 degrees C
    • Humidity, 5 to 100%
    • Altitude, 0 to 10,000 Feet ASL
    • Ice Loading, 1/2" Radial Ice.
  • Back

     Today's Date:   Monday, February 06th 2012 12:40:17 AM MST       Semi-Rigid Cable Tooling     Used Test Equipment     Fresh Local Pistachios!